LogoLogo
FRC Build System
  • Overview and Features
    • Basic Features
    • Advanced Features
    • General Specs
    • Zeroing Module
  • General Info
    • Kit Contents
      • Complete Kits
      • Individual Components
      • Ratio Kits
    • Ratio Options
    • Configurations
    • Maintenance
  • Assembly Instructions
    • Getting Started
    • Standard
      • Steps 1-4
      • Steps 5-8
      • Steps 9-13
    • Inverted
      • Steps 1-4
      • Steps 5-8
      • Steps 9-13
    • Thin (Left)
      • Steps 1-4
      • Steps 5-8
      • Steps 9-14
    • Thin (Right)
      • Steps 1-4
      • Steps 5-8
      • Steps 9-14
    • Wheel Installation
      • Molded Wheel
      • Aluminum Wheel
      • Colson Wheel
  • Applications
    • Tube Mounting
    • Corner Mounting
  • Misc
    • FAQ & Trouble Shooting
    • Changelog
Powered by GitBook
On this page
Export as PDF
  1. Assembly Instructions
  2. Wheel Installation

Colson Wheel

PreviousAluminum WheelNextTube Mounting

Last updated 10 days ago

Vibra-TITE VC-3 Threadmate () is recommended on all bolts that thread into a tapped hole.

Assembly

Insert the 45T Bevel Gear by either tapping it in with a dead blow hammer or using an arbor press.

Be sure to align the bolt holes in the Colson Swerve X2 Wheel with the tapped holes in the 45T Bevel Gear.

Ensure that the 45T Bevel Gear is fully seated before installation. Failure to do so will not allow the wheel to spin smoothly.

Vibra-TITE