Molded Wheel

Kit Contents

WCP Swerve X2 Molded Wheel Hub (WCP-1727)

Part Number	Description	QTY
WCP-1727-001	Swerve X2 - Molded Wheel Hub Male	1
WCP-1727-002	Swerve X2 - Molded Wheel Hub Female	1

94KB

WCP-1727 - Kit Contents.pdf

pdf

Assembly

Vibra-TITE VC-3 Threadmate (Vibra-TITE) is recommended on all bolts that thread into a tapped hole.

Slide the desired Molded Tread onto one half of the Molded Wheel Hub. Align holes in both halves of hubs and press second half into place.

Insert the 45T Bevel Gear and attach with #10-32 x 1"L SHCS bolts. Use these bolts to squeeze both halves of the hub together. Ensure no gaps are left after tightening bolts.

Be sure to align the bolt holes in the Molded Swerve Wheel with the tapped holes in the 45T Bevel Gear.

Ensure that the 45T Bevel Gear is fully seated before installation. Failure to do so will not allow the wheel to spin smoothly.