Steps 5-8
Vibra-TITE VC-3 Threadmate (Vibra-TITE) is recommended on all bolts that thread into a tapped hole.
Step 5
Press the 88T Rotation Gear in by hand. If necessary, use a dead blow hammer to lightly tap it in.
The Bevel Gear Shaft must be installed through the bottom side of the 12mm bearing. Use the 3/8" snap ring to retain the gear and shaft.
The 16t Second Stage Gear for the X2 Ratio Set is on a 18t Center Distance.
The 14t Second Stage Gear for the X4 Ratio Set is on a 16t Center Distance.
X1
18t
X2
16t (18t Center Distance)
X3
16t
X4
14t (16t Center Distance)
Step 6
The 1/4” ID x 5/8” OD bearing can be pressed into the Wheel Fork by hand. Once the bearing is in place, use the #10-32 x 1- 1/2”L bolts to install both forks into the module.
Step 7a
Install the two 15mm ID x 24mm OD bearings into the desired Column Gear. Refer to the Ratio Options page for the correct Column Gear for your selected ratio.
Step 7b
Use the 1/4"-20 x 1/2"L bolt to attach the Encoder Shaft. This may be a tight fit so use the bolt to fully seat the Encoder shaft.
Then slide the Cartridge and Column Gear Spacer onto the Encoder Shaft.
Vibra-TITE VC-3 Threadmate (Vibra-TITE) should be used for the 1/4"-20 bolt shown below.
Step 8
Slide the Rotation Gear and Rotation Shaft into position.
Last updated