LogoLogo
FRC Build System
  • Overview and Features
    • General Specs
  • General Info
    • Kit Contents
      • Complete Kit
      • Individual Components
    • Customization
  • Assembly Instructions
    • Getting Started
    • Single Upper Kit
      • Steps 1-4
      • Steps 5-8
    • Battery Rack Kit
      • Steps 1-5
      • Steps 6-9
    • Corner Case Kit
    • Table Kit
      • Steps 1-4
      • Steps 5-9
    • Toolbox Kit
    • SuperCart
      • Steps 1-4
      • Steps 5-8
      • Steps 9-12
      • Steps 13-16
    • SuperStation
  • Misc
    • FAQ & Trouble Shooting
    • Changelog
Powered by GitBook
On this page
  • Step 5
  • Step 6
  • Step 7
  • Step 8
  • Step 9
Export as PDF
  1. Assembly Instructions
  2. Table Kit

Steps 5-9

PreviousSteps 1-4NextToolbox Kit

Last updated 10 months ago

Step 5

Take the assembly from Step 1 and set them back in the case in the same layout that was used to mark the drilling locations in Step 4. Use #10-32 x 1.000" L bolts with lock nuts to bolt everything down.

Step 6

Take the assembly from Step 2 and set it in the desired position. Use #10-32 x .500"L Particleboard Screws to secure the assembly into the case.

Step 7

Place your workspace top into position and secure it down using #10-32 x .500"L Particleboard Screws.

Step 8

Place the Main Trim pieces on top of your workspace top and against the case. Secure them with #10-32 x .500"L Particleboard Screws.

Step 9

Secure the Light Shield pieces using the #10-32 x .500"L Particleboard Screws.

The Light Shield should not protrude outside of the case.