LogoLogo
FRC Build System
  • Overview and Features
    • General Specs
  • General Info
    • Kit Contents
      • Complete Kit
      • Individual Components
    • Customization
  • Assembly Instructions
    • Getting Started
    • Single Upper Kit
      • Steps 1-4
      • Steps 5-8
    • Battery Rack Kit
      • Steps 1-5
      • Steps 6-9
    • Corner Case Kit
    • Table Kit
      • Steps 1-4
      • Steps 5-9
    • Toolbox Kit
    • SuperCart
      • Steps 1-4
      • Steps 5-8
      • Steps 9-12
      • Steps 13-16
    • SuperStation
  • Misc
    • FAQ & Trouble Shooting
    • Changelog
Powered by GitBook
On this page
  • Step 1
  • Step 2
  • Step 3
  • Step 4
Export as PDF
  1. Assembly Instructions
  2. Table Kit

Steps 1-4

PreviousTable KitNextSteps 5-9

Last updated 10 months ago

Step 1

The outside table pillars will be assembled by bolting the Upper Table Support (Big) and Lower Table Support (Big) to the table legs using #10-32 x .375" L bolts into thin Lock Nuts (#10-32).

Repeat this step for the other outside table pillar.

Step 2

The middle table pillar will be assembled by bolting the Upper Table Support (Small) and Lower Table Support (Small) to the table legs using #10-32 x .375" L bolts into thin Lock Nuts (#10-32).

Step 3

Line up the assembly inside the case, make sure everything is square and straight. Take a sharpie and mark all the holes to drill to 0.201" into the wood.

Do not drill out the holes in this step.

Step 4

Remove the assembly from the case and drill holes. If any of the holes line up with any metal or handles we recommend not drilling those holes.