Aluminum Wheel

Vibra-TITE VC-3 Threadmate () is recommended on all bolts that thread into a tapped hole.

Insert the 45T Bevel Gear into the Aluminum Wheel. This may be a tight fit. A dead blow hammer or an arbor press can be used to press the bevel gear into place. Tighten all bolts to ensure the bevel gear is flat.

Be sure to align the bolt holes in the Aluminum Swerve Wheel with the tapped holes in the 45T Bevel Gear.

Ensure that the 45T Bevel Gear is fully seated before installation. Failure to do so will not allow the wheel to spin smoothly.

PreviousWheel Assembly NextMolded Wheel (High Grip)

Last updated 17 days ago