Steps 13-17
Step 13
Bolt together the assemblies from steps 11 and 12 as shown in the image below.
Step 14
Bolt together the assemblies from steps 10 and 13 as shown in the image below. The bolt locations are marked in green in the image below.
Step 15
Install the 18t pulleys and the 57t belt onto the assembly from Step 14 and mount the assembly from Step 5 using the 3/4"L bolts.
Step 16
When installing the Wheel Assembly, be sure the 45T Bevel Gear and 15T Bevel Gear are on the same side.
Before installing the wheel assembly, it is necessary to loosen the fork installed in Step 6 for the wheel to slide past the small bevel gear. We recommend loosening the Fork opposite the bevel gear.
Step 17
Apply Lucas Red "N" Tacky grease to all gears after final assembly to ensure smooth operation and reduce wear during use. Once greased, rotate and spin the wheel to distribute the grease evenly before powering up.
After running gearbox for 15-30 minutes, reapply a light amount of grease. Reapply as needed.
Last updated