LogoLogo
FRC Build System
  • Overview and Features
    • General Specs
  • General Info
    • Kit Contents
      • Complete Kits
      • Individual Components
    • Gearbox Selection
      • Ratio Options
    • Configurations
    • Maintenance
  • Assembly Instructions
    • Getting Started
    • Material Cutting
    • Bearing Blocks
    • Cascade Pulley Blocks
    • Single Stage
      • Elevator Mast
      • Carriage
      • General Assembly
      • Chain
    • Multi-Stage
      • Elevator Mast
      • Carriage
      • 2nd Stage
      • Extra Stage
      • General Assembly
      • String & Chain
  • Applications
    • Mounting
  • Misc
    • FAQ & Trouble Shooting
    • Changelog
Powered by GitBook
On this page
  • Step 1
  • Step 2
Export as PDF
  1. Assembly Instructions
  2. Single Stage

General Assembly

PreviousCarriageNextChain

Last updated 8 days ago

Vibra-TITE VC-3 Threadmate () is recommended on all bolts that thread into a tapped hole.

Step 1

Slide the carriage assembly into the 1st stage assembly from the front. It may help with installation to lift the carriage up from the bottom and angle it forward a bit. Slide the carriage down and return it to a vertical position.

Once in, the front/back bearings in the carriage and the 1st stage should both be on the same side.

Step 2

Bolt the 3/4" OD Radial Bearings into the Bearing Blocks on the backside of the carriage as indicated in green.

At this point, the elevator carriage should be able to move smoothly up/down, and a small amount of wiggle left/right and front/back is to be expected. This ensures the elevator will not bind.

Vibra-TITE