LogoLogo
FRC Build System
  • Overview and Features
    • General Specs
  • General Info
    • Kit Contents
      • Complete Kits
      • Individual Components
    • Gearbox Selection
      • Ratio Options
    • Configurations
    • Maintenance
  • Assembly Instructions
    • Getting Started
    • Material Cutting
    • Bearing Blocks
    • Cascade Pulley Blocks
    • Single Stage
      • Elevator Mast
      • Carriage
      • General Assembly
      • Chain
    • Multi-Stage
      • Elevator Mast
      • Carriage
      • 2nd Stage
      • Extra Stage
      • General Assembly
      • String & Chain
  • Applications
    • Mounting
  • Misc
    • FAQ & Trouble Shooting
    • Changelog
Powered by GitBook
On this page
  • Step 1
  • Step 2
  • Step 3
  • Step 4
  • Step 5
Export as PDF
  1. Assembly Instructions
  2. Multi-Stage

Elevator Mast

PreviousMulti-StageNextCarriage

Last updated 8 days ago

Vibra-TITE VC-3 Threadmate () is recommended on all bolts that thread into a tapped hole.

Step 1

Assemble the Elevator Mast Vertical Tube with an aluminum tube plug and appropriate plastic tube plug sleeve. The tube plug can be installed using #10-32 x 3/8”L bolts.

Repeat this step for both Elevator Mast Vertical Tubes.

Step 2

Bolt the assembled vertical tubes for the mast to the Elevator Base Tube. The bottom face of the tube should be drilled to 3/8”, providing adequate clearance so the #10-32 x 3/8”L bolts can be installed inside the tube.

Step 3

Install the Clamping Bearing Blocks as shown in the image below. The Bearing Blocks use 1/2” hole spacing.

Repeat this step for both sides of the Elevator Mast.

Make sure to install the Bearing Blocks with only one of the 3/4" OD Radial Bearings on the back of the mast. This will allow for an easy installation process.

Step 4

Attach the Elevator Mast Cross Tube to the Elevator Mast Vertical Tubes using four #10-32 bolts and 2” long spacers. While the tube can be lower, it is recommended to mount it as high as possible to increase the strength of the elevator mast.

Make sure to install the bearing blocks with the 3/4” radial bearings on the back of the mast and the bearing blocks without the 3/4” radial bearings on the front.

Step 5

Drill the holes marked in green on one of the Centered Bearing Plates to be clearance for #10-32. Once that is done, press the 1/2" Rounded Hex Bearings into both plates. Install both plates as shown in the image below using two #10-32 x 1-1/2"L bolts.

Vibra-TITE