Carriage
Last updated
Last updated
Assemble the Carriage Horizontal Tube with aluminum tube plugs and appropriate plastic tube plug sleeves. The tube plugs can be installed using #10-32 x 3/8"L bolts.
Repeat this step for both Carriage Horizontal Tubes.
Bolt the Carriage Vertical Tubes to the assembled Carriage Horizontal Tubes using the #10-32 x 1 1/2"L bolts When assembled, the #10-32 x 1 1/2"L bolts will sit inside the Elevator Clamping Block.
The two bottom clamping blocks must sit higher up to provide clearance for an extra ratchet plate.
The bushings should be a slip or a light press fit into the vertical carriage tube. Install the bearings into the plates before installing the plates onto the carriage.
Use four #10-32 x 3"L bolts to attach the 1/2" Hex Ratchet Plates onto the carriage assembly.