Bearing Blocks
The Elevator Inline Clamping Bearing Block (WCP-0897) can be assembled with bearings before assembly of the Elevator.
Assembly Instructions
The following shows the General Assembly Instructions for the Inline Clamping Bearing Block.
Vibra-TITE VC-3 Threadmate (Vibra-TITE) is recommended on all bolts that thread into a tapped hole.
Step 1
Slide all the appropriate bearings onto the Dowel Pin.
Step 2
Slide the assembly from Step 1 into the Clamping Block. The bearing should fit in the slots on the block. The dowel pin will be constrained by the Shoulder Bolts installed in Step 3.
Step 3
Bolt the bearing and spacer stack-up to the block as shown in the images below.
Last updated