Elevator Corner Bearing Block with Tube Plug

Assembly Instructions

The following page shows the General Assembly Instructions for the new Inline Bearing Block.

Vibra-TITE VC-3 Threadmate (Vibra-TITE) is recommended on all bolts that thread into a tapped hole.

Step 1

Slide the 1/4" ID x 3/4" OD Radial Bearings onto the Dowel Pin.

Step 2

Drop the assembly from Step 1 into the Bearing Block. The bearings should easily fall into the slots on the block. The dowel pin will be constrained by the Cam Followers and Spacers installed in Step 3.

Step 3

Bolt the bearing and spacer stack-up to the block as shown in the images below.

The 7/32"L Spacers can be replaced with the included 1/16"L Spacers as shown in the images below. Refer back to the Configurations section for more information.

7/32"L Spacer

1/16"L Spacer