LogoLogo
FRC Build System
  • Overview and Features
  • General Info
    • Individual Components
    • Configurations
  • Maintenance
  • Assembly Instructions
    • Getting Started
    • Inline Bearing Block
    • Clamping Block
    • Inline Clamping Bearing Block
  • Applications
    • Mounting Examples
  • Misc
    • Changelog
Powered by GitBook
On this page
  • Assembly Instructions
  • Step 1
  • Step 2
  • Step 3
Export as PDF
  1. Assembly Instructions

Inline Bearing Block

PreviousGetting StartedNextClamping Block

Last updated 9 days ago

Assembly Instructions

The following page show the General Assembly Instructions for the Inline Bearing Block. The appropriate images for the three configurations will be shown side by side.

Vibra-TITE VC-3 Threadmate () is recommended on all bolts that thread into a tapped hole.

This product is packaged with the 3/4" Radial Bearing. If different bearings are needed visit our .

Step 1

Slide all the appropriate bearings and washers on to the Dowel Pin. The table below lists the number of washers used for each bearing configuration.

If you are using 1/2” and 5/8” bearings instead of the standard 3/4” bearings, you can substitute in 0.03” washers to cut down on the part count.

Bearing Size
0.01” Washer QTY

1/2” OD

20

5/8” OD

18

3/4” OD

4

Step 2

Slide the assembly from Step 1 into the Bearing Block. The bearing and washers should all fit in the slots on the block. The dowel pin will be constrained by the Shoulder Bolts and 3D Printed Spacers installed in Step 3.

Step 3

Bolt the bearing and spacer stack-up to the block as shown in the images below. The sizes of the spacers required for each bearing configuration is listed in the table below.

The 1/2” Bearing Configuration does not require an Aluminum Spacer.

Bearing Size
3D Printed Spacer Length
Aluminum Spacer Length

1/2” OD

1/8”

N/A

5/8” OD

3/16”

1/16”

3/4” OD

1/4”

1/8”

Vibra-TITE
Ball Bearings Product Page