Getting Started
Last updated
Last updated
Refer back to the and pages to ensure that all necessary parts are located before starting assembly steps.
These tools are required for the assembly of the GreyT Telescope.
Snap ring pliers (For 1/2" snap rings)
Allen keys
3/32"
1/8"
5/32"
Arbor press
Drill
Drill bit
#9
C-clamp or other type of clamp
Unless stated otherwise, assembly instructions are interchangeable between the different sizes of Top Blocks and Bottom Blocks.
Check for any remaining support material on all 3D printed parts before assembly.
The following instructions detail how to assemble the GreyT Telescope.
Vibra-TITE VC-3 Threadmate () is recommended on all bolts that thread into a tapped hole.
Apply grease to all gears after final assembly to ensure smooth operation and reduce wear during use.CommentShare feedback on the editor.
