Basic Frame
Last updated
Last updated
The following instructions detail how to assemble the basic frame for the GreyT Shooter (9.5”).
Press the 1/2” ThunderHex ID x 1-1/8” OD Flanged bearing into the Shooter Side Plates. The bearing will be installed from the opposite side for the other Shooter Side Plate.
It is recommended not to skip any standoffs between the first and last holes used on the plate.
Bolt all four standoffs into the holes for the wheel guard at the front of the shooter.
Use the remaining #10-32 x 2-1/4”L Bolts and 3/8” OD x 1-3/4”L Spacers to attach the other Shooter Side Plate.
Cut a piece of 1/16” Polycarbonate Plastic for the backing of the shooter hood. It is recommended to cut this piece of plastic roughly 1” longer so you can wrap the plastic underneath the lowest standoff. This prevents the game object from being caught on the plastic as it feeds through the shooter.
Zip ties are the recommended means of attaching the plastic backing. Start from the first standoff and work your way up. Drill one set of holes and then secure with the zip tie before moving on to the next standoff.
Install the Aluminum Nutstrips to the bottom of the shooter. The Nutstrip that comes with the shooter can be cut into four 1-1/2” long pieces for the shooter. These pieces can be installed with #10-32 x 1/2”L Bolts.
The standoff and spacers used are shown in the image below. Install them in the correct set of holes to achieve the desired compression and exit angle. See the page with the “ for more information.