Steps 5-8

Step 5

Cut a piece of 1/16” polycarbonate for the backing of the shooter hood. It is recommended to cut the piece slightly longer, about 1”, so that this extra length can be wrapped under the first standoff. This prevents the game object from being caught on the plastic as it feeds through the shooter.

Zip ties are the recommended means of attaching the plastic backing. Start from the first standoff and work up. Drill one set of holes and then secure with the zip tie before moving on to the next standoff.

Step 6

Attach 1” x 1” VersaFrame Aluminum Angle to either side of the shooter with bolts or rivets.

Step 7

Center the Limelight Mount between the Shooter Side Plates. Secure the Limelight Mount to the two top most standoffs using four #10-32 x 1”L bolts and nuts.

Do not over tighten the bolts as this will cause the plates to bend.

Step 8

Attach the Limelight to the Limelight mount using four #10-32 x 2”L bolts and nuts.

The bolts need only be tightened so that the Limelight is not loose on the plate. Over tightening the bolts may cause damage to the case or the electronics inside.