Compatibility

MotionX Compatibility

2" Bearing Block

All Clamping Bearing Blocks are compatible with parts that have the MotionX Pattern.

2" Bolt Circle

The 2" pitch spacing is widely compatible with a variety of products, making it easier for FRC teams to design and build their robots. Allowing for standard #10-32 hardware to be used.

1" From Center

This configuration allows teams to opt for 1" From Center gears for lightweight or high-speed gearboxes, prioritizing weight and size reduction.

Because of the 2" width of the block, the slot is open ended.

Clamping System

The highlighted holes allow for a #10-32 bolt and 3/8" OD spacer to be used with either 1" or 2" tubing with out creating any collisions.

2.5" Bearing Block

2" Bolt Circle

The 2" pitch spacing is widely compatible with a variety of products, making it easier for FRC teams to design and build their robots. Allowing for standard #10-32 hardware to be used.

1" From Center

This configuration allows teams to opt for 1" From Center gears for lightweight or high-speed gearboxes, prioritizing weight and size reduction.

Clamping System

The highlighted holes allow for a #10-32 bolt and 3/8" OD spacer to be used with either 1" or 2" tubing with out creating any collisions.

WCP Cam Compatibility

The 2.5" wide clamping bearing blocks are compatible with the WCP Cam (WCP-0882) in the 2" tall tube configuration, while all clamping bearing blocks are compatible with the Cam in the 1" tall tube configuration.

2" Tall Tube

Minimum Cam Center Distance

Maximum Cam Center Distance

1" Tall Tube

Minimum Cam Center Distance

Maximum Cam Center Distance

20DP Gear Compatibility

The Clamping Bearing Blocks can be used to make basic gear trains by stacking the blocks next to each other on any 2" tall tube.

80t Gear Train

The gear teeth for a center distance is calculated by adding the tooth count of both gears together. [Ex: 40 + 40 = 80]

90t Gear Train

The gear teeth for a center distance is calculated by adding the tooth count of both gears together. [Ex: 40 + 50 = 90]

100t Gear Train

The gear teeth for a center distance is calculated by adding the tooth count of both gears together. [Ex: 50 + 50 = 100]