Assembly

Assembly Prep

Refer back to the Individual Components page to ensure that all necessary parts are located before starting assembly steps.

Tools Required For Assembly

• Allen Key - 1/8"

Blue Loctite (McMaster P/N 1004A12) is recommended on all bolts that thread into a tapped hole.

Basic Assembly

Step 1

Slide the Clamping Bearing Blocks onto the tube. Make sure the tube has a clearance hole or slot for the shaft before assembly.

2" Centered

2" Offset

Make sure the arrows on the tapped and clearance bearing blocks are pointing in the same direction.

2.5" Centered

2" Offset

Make sure the arrows on the tapped and clearance bearing blocks are pointing in the same direction.

Step 2

Thread the four #10-32 x 1.500" L Button Head Bolts through the clearance block and into the tapped block.

Longer bolts will be needed if you are clamping around tubing that is wider than 1".

2" Centered

2" Offset

2.5" Centered

2" Offset

Motor Mounting

In order to mount a motor to the 2.5" Bearing Blocks, use the two .375" OD x .125" depth c-bore holes.

The 2" Bearing Blocks are not able to have motors mounted to them.