SplineXL Bearing Blocks
Last updated
Last updated
All Clamping Bearing Blocks are sized to clamp around any box tube that is 1" or 2" tall. In order to clamp around 1" tall tube, the blocks must be rotated onto their side as shown in the image below.
All Clamping Bearing Blocks have a SplineXL ID. This means it is compatible with the WCP SplineXL Tube (WCP-0918).
All Clamping Bearing Blocks come with a 1.4" OD x 0.0625" deep c-bore that can be used to trap the flanges of bearings or bushings.
This feature is only compatible with bearings/bushings that are 1.125" OD, with a flange that is smaller than 1.4", and no thicker than 0.0625".
The 2.5" width Clamping Bearing Blocks (WCP-0592 and WCP-0593) both come two 0.375" OD x .125" deep c-bores that can be used to bolt parts directly to the block.
This feature is only compatible with #10-32 Button Head Bolts.
Two blocks (WCP-0591 and WCP-0593) come with an offset output. This means that when mounted to a 2" tall box tube, the center of the SplineXL bore will be offset by 0.0625" from the centerline of the tube.
This feature is only on the 2" tube configuration. The SplineXL output of all Clamping Bearing Blocks is centered for the 1" tube configuration.
