Getting Started
Assembly Prep
Refer back to the Individual Components page to ensure that all necessary parts are located before starting assembly steps.
Tools Required For Assembly
These tools are required for the assembly of the WCP Stub Rollers
Snap Ring Pliers (For 1/2" Snap Rings)
Allen Keys
1/8"
Assembly Instructions
The following sections will cover the basic assembly instructions for the WCP Stub Rollers.
Step 1
The 1/2" ID bearings will be installed as shown below. The bearings should be recessed into the Roller Hub.
Bearings may be a press fit. Use an arbor press to ensure the bearings are fully seated.
Step 1B (Optional)
This step is optional.
The inside bearing can be retained in the Roller Hub Assembly using a snap ring. This snap ring is not necessary and is only intended to be used when the rollers will be used with a shaft running throughout. This will prevent the bearing from backing out during use.
Step 2
Insert the correct Stub Shaft into the Roller Hub assembly and secure this with the 1/2" Snap Ring. Refer back to the compatibility chart to ensure that the correct Stub Shaft is being used for the Roller Hub.
Step 3
Insert the assembled Stub Roller Hub Assembly into the Tube and secure using #10-32 x 1/4"L bolts.
Step 4
Thread the bolt through your desired mounting surface and into the Stub Shaft. Use the Stub Shaft Wrench to hold the Stub Shaft in place while tightening the bolt.
The table below will show what bolt to use for each Stub Shaft length. Lengths are determined using a 1/4" thick mounting surface, anything thicker than this will need a longer bolt.
#10-32 x 2"L Bolt
#10-32 x 2-1/2"L Bolt
#10-32 x 3"L Bolt
Last updated