Step 1-4
Vibra-TITE VC-3 Threadmate (Vibra-TITE) is recommended on all bolts that thread into a tapped hole.
Step 1
Install the 1/2" ID x 1-1/8" OD Flanged Bearing as shown below. The bearing should be a slip fit into the plate. If needed an arbor press can be used to press the bearing in. Use the two #10-32 x 1/4"L Bolts to prevent the bearing from backing out during operation.
Step 2
Install the 1/2" Rounded Hex ID x 1-1/8" OD Flanged Bearing as shown below. The bearing should be a slip fit into the plate. If needed an arbor press can be used to press the bearing in.
Step 3
Install the 3/8" ID x 7/8" OD Flanged Bearing as shown below. The bearing should be a slip fit into the plate. If needed an arbor press can be used to press the bearing in. Use the two #10-32 x 1/4"L Bolts to prevent the bearing from backing out during operation.
Step 4
We recommend that you cut the drive shaft to the correct length before installation.
Slide desired gears, drive sprockets/pulleys, and spacers onto shaft.
Last updated