Take the assembly from Step 1 and set them back in the case in the same layout that was used to mark the drilling locations in Step 4. Use #10-32 x 1.000" L bolts with lock nuts to bolt everything down.
Take the assembly from Step 2 and set it in the desired position. Use #10-32 x .500"L Particleboard Screws to secure the assembly into the case.
Place your workspace top into position and secure it down using #10-32 x .500"L Particleboard Screws.
Place the Main Trim pieces on top of your workspace top and against the case. Secure them with #10-32 x .500"L Particleboard Screws.
Secure the Light Shield pieces using the #10-32 x .500"L Particleboard Screws.
The Light Shield should not protrude outside of the case.
The following sections will have all necessary information for the assembly of the SuperPit Table Kit.
The Table Kit does not include a workspace top.
The outside table pillars will be assembled by bolting the Upper Table Support (Big) and Lower Table Support (Big) to the table legs using #10-32 x .375" L bolts into thin Lock Nuts (#10-32).
Repeat this step for the other outside table pillar.
The middle table pillar will be assembled by bolting the Upper Table Support (Small) and Lower Table Support (Small) to the table legs using #10-32 x .375" L bolts into thin Lock Nuts (#10-32).
Line up the assembly inside the case, make sure everything is square and straight. Take a sharpie and mark all the holes to drill to 0.201" into the wood.
Do not drill out the holes in this step.
Remove the assembly from the case and drill holes. If any of the holes line up with any metal or handles we recommend not drilling those holes.
