Steps 1-3
Piston is not included. Can be purchased from McMaster (P/N 1691T142)
Step 1
These will come pre-assembled. This step is used if you need to disassemble of change from the 1/2" hex cone to the 3/8" hex cone.
Step 2
Thread the brake cone onto rod of cylinder. The threads of the shoulder bolt are relatively short so Loctite is recommended to be used.
Step 3
The two #10-32 x 1.5”L bolts must be installed first due to the piston covering the heads of these bolts once the piston is mounted.
Last updated