WCP-0285 - Battery Mount (Vertical)

Recommended Parts to Buy (Spacer Version)

Recommended Parts to Buy (Standoff Version)

The SB50 can be mounted with a #6-32 bolt and nut or by tapping the SB50 to #8-32 and using a bolt. The SB50 that comes from the battery can then be secured with the second hole in a variety of ways. Teams can use their preferred method:

• Top most hole that a thumbscrew (tap the SB50) can be installed in • Run a zip tie through the hole around the connector from the battery • Run a large zip tie through the cutout for the strap and around both SB50’s

The Battery Box kit is one of the easiest ways to securely mount your robot battery to your chassis. The box can be mounted via any of its attachment holes or even sandwiched around a piece of 2”x1” tubing. Alongside the battery mount are special features designed to mount the 120 amp main breaker and the battery cable connector, giving teams a strongly-attached, predetermined space for these commonly forgotten control system components. Loose battery parts are a thing of the past with the WCP Battery Box!

Notable Features

• Built in SB50 mount with security hole for connecting SB50 • Multiple mounting locations for Main Breaker Mount • Mounting holes work with any set of holes with 2” center to center spacing • Slots for battery strap

Manual Updates

Product Updates

Depending on the desired assembly method, there are two options for the bolts and spacers. Use the desired hardware for your application. • Spacer Option - #10-32 x 2.5”L BHCS, #10-32 Nuts, and 2” Spacer • Standoff Option - #10-32 x 1/2”L BHCS and 2” Threaded Hex Standoffs

Assemble all components in the desired locations. Below is just a recommendation for locations and components.

Assembly Prep

Refer back to the Individual Components page and ensure that all necessary parts are located before starting assembly steps.

Tools Required For Assembly

These tools are required for the assembly of the Battery Mount (Vertical)

• Allen Keys

  • 1/8"

• 3/8" Wrench

Optional tools that may be needed:

• Allen Keys

  • 7/64"

  • 9/64"

• 5/16" Wrench

Battery Mount (Vertical) Assembly Instructions

The following instructions are the recommended method for assembling this product. The Battery Mount is designed to be a flexible product to work in many situations so teams may find an alternate assembly method that better fits their design.

Shown Below are some of the possible mounting locations for the Main Breaker Mount. If desired, the Main Breaker Mount can be omitted from the assembly if a different mounting solution is to be used.

The slots in the Top Plate and Bottom Plate are meant for the Battery Strap (WCP-0385), but a large ziptie can be used in its place.