Basic Features

Side Face Hole Spacing

All holes on the .75” tall sides of the Tube Plugs are .5” from the end of the tube and have .5” spacing between holes. It is recommended to drill these holes using a CNC machine or other hole drilling fixture. If holes are drilled by hand, increase the drilled hole diameter to account for any inaccuracies.

If drilling the holes by hand, refer back to the Drilling Guides to find the jigs to ensure perfectly aligned and positioned holes for effortless installation of WCP Tube Plugs.

1" x 1" Tube Plug

If drilling the holes by hand, use the jig below to ensure perfectly aligned and positioned holes for effortless installation of WCP Tube Plugs.

57KB

1x1 Drill Guide.STEP

Open

1" x 1" Tube Plug Side Face

1.5" x 1.5" Tube Plug

2" x 1" Tube Plug

2" x 2" Tube Plug

Bottom Face Hole Spacing

1" x 1" Tube Plug

1.5" x 1.5" Tube Plug

2" x 1" Tube Plug

2" x 2" Tube Plug

Bolt C-Bore

All updated Tube Plugs now feature a Bolt C-Bore on each of the #10-32 threaded holes located on the bottom face of the block. This feature is designed to be used specifically with the #10-32 x 0.1875" L Alignment Pin (WCP-2115) and provides teams with an additional method of resisting slip and securely locking parts in place.

Section View

Alignment Pin Example