For the complete documentation index, see llms.txt. This page is also available as Markdown.
15mm Pulley Assembly
Step 1
Combine the plastic pulleys by aligning the nubs on one single slice with the matching pocket on the other slice. When assembled, the two halves should sit flush with no gap between them, as shown in the section view below.
Exploded View
Section View
Step 2
Secure the slices by using the three included #2-28 x 3/8"L Thread Forming Screws.
Step 3
Combine the another 24t Pulley Slice onto the pulley from Step 1 by aligning the nubs on one single slice with the matching pocket on the other slice. When assembled, the two halves should sit flush with no gap between them, as shown in the section view below.
Exploded View
Section View
Step 4
Secure the slices by using the three included #2-28 x 3/8"L Thread Forming Screws.
