Inline Clamping Bearing Block

Assembly Instructions

The following shows the General Assembly Instructions for the Inline Clamping Bearing Block.

Vibra-TITE VC-3 Threadmate (Vibra-TITE) is recommended on all bolts that thread into a tapped hole.

Step 1

Slide all the appropriate bearings onto the Dowel Pin.

Step 2

Slide the assembly from Step 1 into the Clamping Block. The bearing should fit in the slots on the block. The dowel pin will be constrained by the Shoulder Bolts installed in Step 3.

Step 3

Bolt the bearing and spacer stack-up to the block as shown in the images below.