Installation

The Bracket used in the following pictures below is shown without the bumpers attached as a reference only.

Step 1

Use the Bracket to line up the mounting holes needed for the Bumper Cones and securely fasten it onto the #10-32 x 3"L SHCS bolt. The Bumper Cones should sit flat on the mounting tube used.

Only one of the Bumper Cones is needed per Mounting Bracket as shown below. All three can be used if desired.

Vibra-TITE VC-3 Threadmate (Vibra-TITE) is recommended on all bolts that thread into a tapped hole.

Step 2

In order to secure the Bumpers, simply fasten the Knob using a 3/8" wrench.

The Knob should sit flat on the Bracket.