SplineXL Bearing Blocks

Clamping Features

1" and 2" Clamping

All Clamping Bearing Blocks are sized to clamp around any box tube that is 1" or 2" tall. In order to clamp around 1" tall tube, the blocks must be rotated onto their side as shown in the image below.

2" Centered

2" Offset

2.5" Centered

2.5" Offset

SplineXL Bore ID

All Clamping Bearing Blocks have a SplineXL ID. This means it is compatible with the WCP SplineXL Tube (WCP-0918).

C-Bores

Bearing Flange C-Bore

All Clamping Bearing Blocks come with a 1.4" OD x 0.0625" deep c-bore that can be used to trap the flanges of bearings or bushings.

Bolt C-Bore

The 2.5" width Clamping Bearing Blocks (WCP-0592 and WCP-0593) both come two 0.375" OD x .125" deep c-bores that can be used to bolt parts directly to the block.

Center Drop

Two blocks (WCP-0591 and WCP-0593) come with an offset output. This means that when mounted to a 2" tall box tube, the center of the SplineXL bore will be offset by 0.0625" from the centerline of the tube.

2" Offset

2.5" Offset