# Step 14-15

{% hint style="success" %}
Vibra-TITE VC-3 Threadmate ([Vibra-TITE](https://www.vibra-tite.com/threadlockers/removable-reusable-threadlockers/vibra-tite-vc-3-threadmate/?gad_source=1\&gad_campaignid=89842748\&gbraid=0AAAAAD2P3YRFs-3Kj4YTX9A4qtZWYdqGQ\&gclid=EAIaIQobChMI0JSks4upjQMVcNPCBB1_ghB9EAAYASAAEgJQp_D_BwE)) is recommended on all bolts that thread into a tapped hole.
{% endhint %}

## Step 14

Insert the 45T Bevel Gear by either tapping it in with a dead blow hammer or using an arbor press.

{% hint style="warning" %}
Be sure to align the bolt holes in the Aluminum Swerve Wheel with the tapped holes in the 45T Bevel Gear.
{% endhint %}

The Wheel Drive Axle is symmetric. The orientation it is assembled in does not matter.

{% hint style="info" %}
The locations of the bolts are marked out in green in the image below.
{% endhint %}

<figure><img src="/files/M56F5anMuuED28YiyWrC" alt=""><figcaption></figcaption></figure>

{% hint style="info" %}
The 1/2" ID x 1 1/8" OD Radial Bearing that is pressed directly into the wheel and not the bevel gear must sit .034" deeper than flush. If the bearing is not pressed all the way into the wheel, the bevel gears will not mesh properly.

The  1/2" ID x 1 1/8" OD Radial Bearing will come pressed into the wheel.
{% endhint %}

<figure><img src="/files/y6nTIpzSJt0ZtPXHUUak" alt=""><figcaption></figcaption></figure>

## Step 15

When installing the Wheel Assembly, be sure the 45T Bevel Gear and 15T Bevel Gear are on the same side.

{% hint style="info" %}
It is easier to install the tread on the wheel before installing the wheel in the module.
{% endhint %}

{% hint style="info" %}
While the image below may show the Non-Flipped configuration, this step is the same for all Swerve X configurations.
{% endhint %}

<figure><img src="/files/k7WSSeWppGhqTPXygL5X" alt="" width="563"><figcaption></figcaption></figure>

## Corner Mounting

For more instructions regarding mounting the Corner Mount modules, see the [Corner Mounting](/welcome/gearboxes/wcp-swerve-x/applications/corner-mounting.md) section.

<figure><img src="/files/bu6CinazdUg7eIMUZmFz" alt=""><figcaption></figcaption></figure>


---

# Agent Instructions: Querying This Documentation

If you need additional information that is not directly available in this page, you can query the documentation dynamically by asking a question.

Perform an HTTP GET request on the current page URL with the `ask` query parameter:

```
GET https://docs.wcproducts.com/welcome/gearboxes/wcp-swerve-x/misc/other-configurations/getting-started/flipped-gears-above/step-14-15.md?ask=<question>
```

The question should be specific, self-contained, and written in natural language.
The response will contain a direct answer to the question and relevant excerpts and sources from the documentation.

Use this mechanism when the answer is not explicitly present in the current page, you need clarification or additional context, or you want to retrieve related documentation sections.