Ctrlk
For the complete documentation index, see llms.txt. This page is also available as Markdown.

Step 1-4

Vibra-TITE VC-3 Threadmate (Vibra-TITE) is recommended on all bolts that thread into a tapped hole.

Step 1

Press both bearings into the motor plate. This should be a light press it. The bearing flanges should both be on the same side.

Step 2

Install the Kraken motor with two #10-32 x 1/2”L bolts.

Install the desired pinion and 1/16” Kraken Spacer.

Step 3

Slide all desired gears and shaft into place.

Refer to the Gear Ratios page for additional information for your selected ratio.

Step 4

Press bearings into the motor plate. This should be a light press fit. The bearing flanges should be on the same side.

PreviousGetting StartedNextSteps 5-10

Last updated