Ctrlk
For the complete documentation index, see llms.txt. This page is also available as Markdown.

Motor Mounting

If you installed either the Male or Female Hex Input Couplers during the Shaft Installation process, you can skip the following sections and proceed to the 1-3 Stage Assembly Steps

Kraken X60 | CIM | Mini CIM | NEO

Install the Kraken X60 onto the Input Block using the #10-32 x 3/8"L bolts provided.

Then place the SplineXS Input Coupler onto the motor shaft as shown below.

Install the CIM motor onto the Input Block using the #10-32 x 3/8"L bolts provided.

Then place the 8mm Keyed Input Coupler onto the motor shaft as shown below.

Ensure that the 2mm Key is placed and fully seated into the keyed motor shaft.

Install the Mini CIM motor onto the Input Block using the #10-32 x 3/8"L bolts provided.

Then place the 8mm Keyed Input Coupler onto the motor shaft as shown below.

Ensure that the 2mm Key is placed and fully seated into the keyed motor shaft.

Install the NEO motor onto the Input Block using the #10-32 x 3/8"L bolts provided.

Then place the 8mm Keyed Input Coupler onto the motor shaft as shown below.

Ensure that the 2mm Key is placed and fully seated into the keyed motor shaft.

The Kraken X60, CIM, and NEO motors have mounting holes on a 2" Bolt Circle as shown below. These are the holes to be used during the mounting process.

Kraken X44

Install the Kraken X44 and the SplineXS Input Coupler onto the Input Block using the #10-32 x 3/8"L bolts provided.

The Kraken X44 motors have mounting holes on a 1.375" Bolt Circle as shown below. These are the holes to be used during the mounting process.

PreviousInput Coupler Installation
Next1-3 Stage Assembly

Last updated