Kit Contents

WCP Swerve X2 Molded Wheel Hub (WCP-1727)

Assembly

Slide the desired Molded Tread onto one half of the Molded Wheel Hub. Align holes in both halves of hubs and press second half into place.

Insert the 45T Bevel Gear and attach with #10-32 x 1"L SHCS bolts. Use these bolts to squeeze both halves of the hub together. Ensure no gaps are left after tightening bolts.

Assembly

Insert the 45T Bevel Gear by either tapping it in with a dead blow hammer or using an arbor press.

Kit Contents

WCP Swerve X2 Aluminum Wheel Hub (4" OD x 2" WD, 1.125" Bore) (WCP-1729)

Assembly

Insert the 45T Bevel Gear into the Aluminum Wheel. This may be a tight fit. A dead blow hammer or an arbor press can be used to press the bevel gear into place. Tighten all bolts to ensure the bevel gear is flat.

Tread Cutting

When cutting tread for the Swerve X Wheel, you must know which type of tread you are using. The type of tread will affect the hole pattern and overall length of tread needed. We recommend using 3 Ply Black Neoprene and the pattern is based on that material.

The following pages will include all necessary information for the three available wheel configurations for the Swerve X2.