1 of 1

Steps 9-12

Blue Loctite (McMaster P/N 1004A12) is recommended on all bolts that thread into a tapped hole.

Step 9

For all configurations, the motors will be mounted to the Motor Spacer using #10-32 x 1/2”L bolts. The pinions are retained using #10-32 x 1/4”L pan head bolts.

Clock the motors in the desired direction in this step.

For the Drive Pinion refer back to the Ratio Options page.

Step 10

Install the Encoder Mount using two #10-32 x 1/2”L bolts. Remove the board from the case and fit it into the cutout in the 3D Printed Encoder Mount. Use the top half of the Encoder case and the long thread forming screw from the Encoder to attach the sensor.

Step 11

Install the Drive and Rotation Motors using the #10-32 x 1/2"L bolts as shown below.

The Drive Motor is mounted in the center for the picture below, for other mounting locations refer back to the Configurations page.

Step 12

The Wheel Assemblies can be found using the links below.

Molded Wheel, Aluminum Wheel, Colson Wheel

When installing the Wheel Assembly, be sure the 45T Bevel Gear and 15T Bevel Gear are on the same side.

Before installing the wheel assembly, it is necessary to loosen the fork installed in Step 6 for the wheel to slide past the small bevel gear. We recommend loosening the Fork opposite the bevel gear.

Corner Mounting

For more instructions regarding mounting the Corner Mount modules, see the Corner Mounting section.

It is recommended to use either the Top or Bottom Support Plate to strengthen the corner of your frame.